PACCAR SPN 1569 FMI 31: Meaning, Causes & Fix

Backprobe the sensor connector and measure reference voltage, signal, and ground. If the 5V reference is present and ground is good, but the signal is out of range, the sensor is likely bad. If reference voltage is missing or unstable, the problem is in the wiring or ECM. A wiggle test on the harness while monitoring live data will reveal intermittent connections.

It depends on the sensor. Non-critical sensors (barometric pressure, fuel temperature) typically trigger CHECK SOON codes and the engine runs on a default value. Critical sensors (accelerator pedal, crankshaft position) can cause stalling or no-start conditions. If the engine runs normally despite the code, you can usually drive to a repair facility, but do not ignore the code indefinitely.

CAN bus faults are caused by wiring damage (chafed or cut wires), corroded connectors, failed terminating resistors, or a faulty module that corrupts bus communication. Heavy-duty trucks use J1939 CAN which requires 120-ohm terminating resistors at each end of the bus. Measuring 60 ohms across CAN high and CAN low (with power off) confirms the bus is intact.

A new ECM for a heavy-duty diesel engine costs $1,500–$4,000 for the part alone, plus 3–6 hours of labor for installation, programming, and parameter setup. Remanufactured ECMs are available for $800–$2,000. Always verify the ECM is truly faulty before replacing — many ECM codes are caused by wiring or sensor issues, not the ECM itself.

Moisture ingress into sensor connectors causes corrosion and intermittent electrical contact. This is especially common at the engine harness pass-through connector (where wires enter the valve cover) and at under-hood sensor connectors that are not properly sealed. Dielectric grease on connector pins and OEM-rated weatherpack connectors help prevent moisture-related faults.

No. This is a STOP ENGINE-level fault. Continued operation will cause severe engine damage including potential catastrophic failure. Pull over safely and diagnose before restarting. Tow the vehicle to a service facility if the root cause cannot be identified and resolved at roadside.

1) Pull over at the first safe location — use hazard lights and reflective triangles if on a highway shoulder. 2) Shut down engine. 3) Check for obvious issues: fluid leaks, smoke, loose connections, unusual odors. 4) Scan for secondary fault codes using a dash display or diagnostic tool — these often point to the root cause. 5) Call roadside assistance if unable to resolve. Do not attempt to limp the vehicle to a shop.

Ignoring a STOP ENGINE code can result in: turbocharger failure ($3,000–$8,000), engine seizure requiring complete overhaul ($15,000–$40,000), or fire risk from leaking fuel/oil contacting hot exhaust components. If this code is accompanied by low oil pressure or high coolant temperature, engine failure may occur within minutes of continued operation.